Stewed beef in a slow cooker with onions

Extremely soft and very tasty! Eats instantly! Absolutely everyone will like stewed beef in a slow cooker with onions, because it turns out the most tender. The meat is stewed with butter, and it is this that adds a delicious creamy note to the finished dish.
135
162034
Skylar TurnerSkylar Turner
Author of the recipe
Stewed beef in a slow cooker with onions
Calories
337Kcal
Protein
24gram
Fat
31gram
Carbs
2gram
*Nutritional value of 1 serving

Ingredients

ServingsServings: 4

Step-by-step preparation

Cooking timeCooking time: 1 hr 40 mins
  1. STEP 1

    STEP 1

    How to make juicy and soft beef stew in a slow cooker with onions? Prepare the necessary ingredients. Any boneless beef pulp suitable for baking or frying is suitable. Rinse the meat under running water and remove tendons and excess fat, if any. Cut the beef into medium-sized portions. There is no need to lubricate the multicooker bowl with anything beforehand. Just put the chopped beef into it.

  2. STEP 2

    STEP 2

    Peel the onions. I preferred to chop the onion into a medium cube. But you can cut it into thin strips. And if you chop the onion as finely as possible, it will be practically indistinguishable in the finished dish. It is better to use white or yellow onions. Red (or purple) will look less attractive in the finished dish.

  3. STEP 3

    STEP 3

    Grate the butter on a coarse grater and transfer it to the multicooker bowl. Instead of using a grater, you can simply use a knife to cut the butter into smaller pieces. Or you can put it in a whole piece. There will be absolutely no difference. The oil can be used either at room temperature or fresh from the refrigerator.

  4. STEP 4

    STEP 4

    It's time for seasonings and spices. Salt the meat to taste, add a small bay leaf and ground hot pepper. At this stage, you can add any of your favorite spices or fresh herbs to the dish. If you use a prepared spice mixture, check to see if it contains salt. Take this point into account so as not to oversalt the finished dish.

  5. STEP 5

    STEP 5

    Pour filtered water into the multicooker bowl so that it covers the meat, and simmer the beef for about 1-1.5 hours on the “Stew” program. If you have a multicooker-pressure cooker, then 40 minutes at low pressure will be enough. But it’s better to check the instructions, since everyone’s multicooker is different. But even if after the specified time the beef is still a little tough, you can simmer it for another 20 minutes until the meat is completely cooked. Bon appetit!

Comments on the recipe

Author comment no avatar
KateriNNa
07.08.2023
4.8
I stew beef this way.
Author comment no avatar
Moderator Ksenia
07.08.2023
4.8
I want to say a huge thank you for the recipe for beef stew in a slow cooker with onions. For the first time, my beef turned out soft. No, not just soft, but tender, very tender, juicy. This recipe is also good because you don’t need to do anything special. You just need to put all the ingredients into the multicooker bowl and turn on the “Stew” mode. On my multicooker, this mode runs for two hours by default. The meat became quite soft after 1 hour and 20 minutes. But I left it to simmer until the end of the mode. After two hours, the meat became tender, very juicy, and incredibly tasty. I will try other ways to cook beef, but this recipe has already become my favorite. Thanks a lot!
Author comment no avatar
Irina Nasipova
07.08.2023
5
Alas, after 2 hours of stewing, the beef seemed raw. Semi gray semi red meat. Polaris steamer. I think there will be a long boil in the stew? For some reason he wasn't there.